An earlier venture. After having some whining with the guys I was playing with, I let them tell me the dimensions a Rhino occupied and I built to them. So, it is a bit higher and wider than a GW model, but they could be lived with although if I make any more, I'll be leaving one thickness of posterboard off each side. Also, I haven't pasted any printed bits on yet, so they are a bit bland. I also have some turrets to do counts as for Whirlwind, Immolator, Exorcist (FW version) and Predator, but they are over at someone's house.
Without any of the added artwork, it is a little hard to see the slope on the front.
Without any of the added artwork, it is a little hard to see the slope on the front.
Side by side, early proxy Rhino vs the official one.
Even counting for the smoke stacks, it is still a bit wide for a Rhino.
You have to love recycling. This is before the card stock paper cover gets on it.
The length was correct, although my STC has a straight back door to jump out of instead of a slanted wimp's ramp.
Nope, the height is wrong too, like the width was when someone else measured one. Oh well, 1 out of 3 ain' bad, right?
RSS Feed